Logic3 PowerPoint LG290 Manuel d'utilisateur télécharger pdf (Page 3)

User Manual English

Setup/Pairing of PowerPoint/Keynote Remote Control

1. Remove the Remote Control from the Holder.

2. Remove the USB Receiver from the back of the Remote Control.

Open the battery lid and put in the battery, replace battery lid.

WARNING: Please ensure that the battery is inserted correctly. If the battery is inserted

incorrectly (reversed polarity), this may cause personal injury as well as damage to your

PowerPoint/Keynote Remote Control

3. Plug the USB Receiver into the USB port of your Note Book.

4. Press the ID Link button on the USB Receiver (Link Indicator will light up).

5. Press and hold the FN and Link button on the remote control until the Link Indicator on the Receiver

starts to blink, this will indicate pairing is successful.

For MAC OS.X. Please follow the below steps (Only to be performed the first time the remote

is used):-

（1） When you first plug-in the Receiver, the Mac OS X keyboard pairing window will be displayed

on screen.

（2） Follow Pairing as explained in Setup/Pairing of PowerPoint/Keynote Remote Control

（3） Click 'Continue’ on the Keyboard Setup Assistant.

Note : PowerPoint/Keynote Remote Control is designed to be seen by your system as a

keyboard to enable you to use it without installing additional software drivers (re-spin this as

needed).

1 2 3 4 5 6 7 8 ... 43 44

Pas de commentaire

Logic3 PowerPoint LG290 Manuel d'utilisateur Page 3